duallang

Thursday, September 12, 2013

Garmin Edge 800 vs Edge 810 - Hardware comparison

Curiosity is a bad thing...I just dissasembled my Garmin Edge 800 and Edge 810 to find internal differences.  This might be helpful to somebody else.








Lets go

On the outside they are identical... just different colors:
Garmin Edge 800 vs Garmin Edge 810
On the backside, there are 6 TORX screws. After removing them, the touchscreen sensor panel can be removed (just be careful with the flex cable). This procedure is identical in both units.

Garmin Edge 800/810 touchscreen connector

There are 2 TORX screws holding the lcd panel. 

Garmin Edge 800/810 LCD screen
After removing the LCD screen, the main board can be extracted.. little pressure and the connector releases
Garmin Edge 800/810 dissasembly

Both touchscreen sensors are identical
Garmin Edge 800/810 Touchscreen
both LCD screens are identical
Garmin Edge 800/810 LCD panel
Same batteries. Batteries are hold in place with some soft glue.. below them there the little speaker.
Garmin Edge 800/810 battery
main boards: edge 800 on the left, edge 810 on the right
Garmin Edge 800/810 main pcb
backside of the main boards after removing the RF shield

Same barometer (MS5607-02BA01)


same GPS LNA (Infineon BGM781N11)


same GPS frontend (ST STA5620C)


The 800 has a Samsung MCP memory K5 that combines in side the same IC a MobileDDR RAM running at 166MHz, 256Megabits en 16 wide bus and a NAND Flash of 1Gigabit in an 8 wide bus (K521F57ACA-B060)

El 810 has a similar spec´d RAM+FLASH but its Memocom brand instead of samsung


Both units use an ARM cpu manufactured by ST for Garmin.. By looking at the P/N it seems that the 810 has a different (better?) cpu


Voltage regulation is identical in both units


Both units share the same SD/MMC level converter (WM406L)
Both units use the same fuel gauge ic (Maxim 17040)
I couldnt id the rest of the IC.. if somebody recognizes any of them, please let me know


800 uses NordicSemi nRF24AP2 for ANT+ (8 channels)

810 uses Texas Intruments CC2567 which integrates ANT and BT inside same silicon.Next 2 pics shows 810 ANT/BT:


As we can see, the 800 and 810 are very similar devices. They basically added BT, perhaps a faster cpu (not confirmed) and they deployed a new firmware

I dont recommend upgrading from 800 to 810 at this time... 810 software is still buggy, Livetrack does not work well (probably because IOS/Android apps are buggy) and Turn by Turn navigation will work sometimes for part of a route but most of the times it will crash the unit without any warning.

5 comments:

  1. This comment has been removed by the author.

    ReplyDelete
  2. Hello,

    I have a problem with smd Connector for garmin 800 that connects main board with touchscreen, can you tell me the name of the connector or link where to buy it? Thanks in advance.

    ReplyDelete
  3. Hi, the power button on my Edge 800 doesn't work. I can only use the device by opening and removing the mainboard and plugging it back into the power connector. I'd like to try replacing or resoldering the power button in case it has failed. Could you suggest where I would get a replacement power button part please? Thanks!

    ReplyDelete
  4. Me gustaría saber si la carcasa del Garmin 810 sirve para el Garmin 800

    ReplyDelete